Fike CIE-A-200 Single Loop Addressable Fire Alarm Panel

Summary

The CIE-A-200 Addressable Fire Alarm Control Panel is a one loop panel capable of supporting up to 200 devices* with a maximum loop length of 2KM, the panel also provides two configurable monitored input circuits, 2 configurable monitored output circuits, 2 configurable + 1 fault relay and also a Peripheral bus circuit to add up to 8 repeater panels.

The system may be configured utilising 3 alarm stages with full ‘Zone to Zone’ Cause and Effect across all 32 panel zones with provision to include alarm confirmation and delay timers. An additional 32 output zones are also provided for more complex Cause and Effect programming.

The CIE-A-200 control panel is compatible with Fike’s addressable range of devices and utilizes soft addressing principles eliminating the need for the installer to physically address each device whilst also eradicating time spent on faults caused by duplicate addressing. The operating parameters of the devices are configured either from the panel or via the OSP programming software and are then stored within the Flash memory of the device itself. This enhanced digital protocol means less information is needed to be sent between the detector and the host control panel, resulting in faster, more reliable communication.

Cabinet Intallation

Surface Mounting

The three mounting holes provided in the back box should be used to secure the cabinet to a solid wall using suitable screws of at least 50mm in length. Ensure that a minimum gap of 50mm is left between the sides of the back box and any wall or projection (such as another box).

Flush Mounting

An additional cradle (part number 23-0239) is available for use when flush mounting the panel. The cut out size for flush mounting is 354mm (W) x 334mm (H). When flush mounted the panel will sit at a depth of 83mm into cavity and have 36mm protruding from surface.