Apollo XP95 Manual Call Point (55100-905)

The Apollo XP95 Manual Call Point can be installed in an addressable fire alarm system to allow manual notification of fire danger. Pressing the resettable element sends a signal to the alarm control panel in less than 0.2 seconds.

The advanced design of this manual call point allows for wiring continuity testing before fitting and the unit has plug and play terminal connections for extremely quick wiring. It also comes with a backbox for surface mounting. To set the address a seven segment DIL switch can be used at the commissioning stage.

The attractive call point housing is made from a robust red polycarbonate. In an alarm event the single LED on the unit will illuminate red, if there is a fault this will illuminate yellow.

• Part No. 55100-905 
• Call Point Type: deformable element 
• Call Point Principle: operation of a switch 
• Alarm Indicator: red LED 
• Fault Indicator: yellow LED 
• Supply Wiring: 2 wire supply, polarity sensitive 
• Loop Connections L1/L2: terminal block 
• Operating Voltage: 17 to 18 V DC 
• Communication Protocol: 5v to 9V peak to peak 
• Quiescent Current: 100μA 
• Power-up Surge Current: 1mA 
• Alarm LED Current: 4mA 
• Normal Analogue Value: 16 
• Alarm State Value: 64 
• Storage Temperature: -30°C to +80°C 
• Operating Temperature: -20°C to +60°C 
• Humidity: 0% to 95% relative 
• IP Rating: 24 
• Dimensions: 89 x 93 x 26.5 mm (manual call point), 87 x 87 x 32 mm (backbox) 
• Weight: 151g
• Detector Housing: red polycarbonate/ABS